How to connect 2-wire and 3-wire motor without damaging the motor

How to connect 2-wire and 3-wire motor without damaging the motor

Connect 2 motor wires

  1. In the case of Single phase motor (SP, SC model)
    1.1 Connect the two power wires from the power supply to the two motor power connection points (U and V) according to the wiring diagram attached to the motor.
  2. In the case of Single phase motor (SCL model)
    2.1 Match the motor wires between the top and bottom, 2 pairs (U1-Z1 and U2-Z2).
    2.2 Take the two power supply wires and connect them to point 2.1 according to the wiring diagram attached to the motor.

Connect 3 motor wires

  1. Adjust the Connection bar to match the power supply type, according to the wiring diagram attached to the inside of the power box cover.
  2. Take all 3 power supply wires (3 phases R,S,T) and connect them to each phase of the motor (U1,V1,W1).

Remark 

  1. In this content, the motor shaft rotates counter-clockwise (CCW). To rotate clockwise (CW), swap one pair of motor wires.
  2. This content is for connection to a voltage of 220 volts, 50 hertz (for 2-wire connection) and 380 volts, 50 hertz (for 3-wire connection).
  3. If you need to connect the power outside of this content, you can study the wiring diagram attached to the motor or inside the cover of the electrical box.